TOPIC: Help Need to Id my boat

Hello all tried all kinds of sites everyone says come here. I picked up an old soon to be beauty, but cannot figure out who made her. She is fiberglass 14 ish feet and supposed to be a 1959 with fins it looks like it used to have name plates on rear corners and they may have been rectangular shaped aprox.12" X 1.5" hope this is a clue. I would like to restore to original lay out interior wise.

Thanks Jeff

EDITED BY WEBMASTER: HERE"S YOUR PIC.

We need photos....

Your boat is a 57/58 Skagit 14 hull.
Send a pic of the transom, it should be a sponson bottom.
The fins were either glassed on, or if you grind off the paint and can prove they were part of the deck made in a mold, then someone splashed a new mold for the deck. Which I doubt.
So you're going to have to do some work for final ID.
Go to the Skagit section in Library and look at the 14's.

Thanks no plate anywhere but the fins are factory done not add ons the transom pic hopefully will be attached.

Could very well be a splash of a Skagit 14- a lot of small boat manufacturers got their start with someone else's design. I would figure a successful hull design would be much harder to come up with than a new deck design.

Sometimes ID'ing a boat here takes months and multiple posts. You never know though what someone might come up with once their memory is jogged or they come across something. Today in fact I finally ID'ed a catamaran boat someone posted a long while back as being a Cloud made by Canton Mfg. Co. in Canton, Missouri.

Anyone have any old pics of uniflites saw one with similar lines to my mystery boat

Hello I should have mentoined that it does have fiberglass stringers maybe that will add another clue.